Support

Back Support
I read that HGH Fragment reconstituted with 1 ml water may crystallize or solidify. What would that look like?
I made a vial a few months ago, used it in ten occasions, it was all right in the fridge. I made another recently the same way, used it only once, and then didn't touch it for a week because I was down with a 4-day continuous diarrhea from Reta and was too weak to do anything. I took it out of the fridge a week later, and the vial looks empty, as if everything evaporated, while 9/10 should still be there. Is it possible that it solidified? Should I leave it at room temperature for a few hours?
Yes, that can definitely happen — it sometimes occurs with HGH Frag. Could you please send a photo of the vial?
 
Yes, that can definitely happen — it sometimes occurs with HGH Frag. Could you please send a photo of the vial?

Yep, I see what happened now. The whole thing coagulated on the bottom of the vial. Can I save it by ordering another water and leaving it at room temp for a while, or is it gone?
 

Attachments

  • IMG_20260309_095103.jpg
    IMG_20260309_095103.jpg
    431.2 KB · Views: 12
Yep, I see what happened now. The whole thing coagulated on the bottom of the vial. Can I save it by ordering another water and leaving it at room temp for a while, or is it gone?
Unfortunately, this can sometimes happen with HGH Frag, even when the peptide has been reconstituted correctly.

This is related to its physicochemical properties. HGH Frag (fragment 176–191) contains certain regions of the peptide chain that can interact with each other in solution. Under certain conditions, this can cause the solution to become thicker or develop a gel-like consistency.

There are several reasons why this may occur:
1. Rapid cooling after reconstitution
If the vial is placed in the refrigerator immediately after reconstitution, especially in the coldest part of the fridge, the temperature of the solution drops quickly. At this point, the peptide chains can partially fold and interact with each other, which creates the gel-like effect. If the storage temperature is too low (below ~3–4°C), this can increase the likelihood of this happening.

2. High concentration of the solution
When the peptide is reconstituted with a small amount of water, the concentration becomes higher, which increases the chance of peptide chains interacting with each other. We usually recommend purchasing additional bacteriostatic water and reconstituting with 3 ml.

To reduce the chances of this happening, we usually recommend:
• After reconstitution, allow the solution to sit at room temperature for 5–10 minutes
• Store the vial in the refrigerator door, where the temperature is usually 4–6°C, rather than in the coldest part of the fridge.


And of course, the vial that turned into gel will be replaced for you this time.
 
Unfortunately, this can sometimes happen with HGH Frag, even when the peptide has been reconstituted correctly.

This is related to its physicochemical properties. HGH Frag (fragment 176–191) contains certain regions of the peptide chain that can interact with each other in solution. Under certain conditions, this can cause the solution to become thicker or develop a gel-like consistency.

There are several reasons why this may occur:
1. Rapid cooling after reconstitution
If the vial is placed in the refrigerator immediately after reconstitution, especially in the coldest part of the fridge, the temperature of the solution drops quickly. At this point, the peptide chains can partially fold and interact with each other, which creates the gel-like effect. If the storage temperature is too low (below ~3–4°C), this can increase the likelihood of this happening.

2. High concentration of the solution
When the peptide is reconstituted with a small amount of water, the concentration becomes higher, which increases the chance of peptide chains interacting with each other. We usually recommend purchasing additional bacteriostatic water and reconstituting with 3 ml.

To reduce the chances of this happening, we usually recommend:
• After reconstitution, allow the solution to sit at room temperature for 5–10 minutes
• Store the vial in the refrigerator door, where the temperature is usually 4–6°C, rather than in the coldest part of the fridge.


And of course, the vial that turned into gel will be replaced for you this time.
Thank you. I keep it in the fridge door, there is around 6-7 C there.
 
Will Drostanolone Enanthate be in stock this week again? Would want to order Drostanolone together with this weeks product of the week
 
Ej ekipa. Nedavno sam naručila mk677 i nakon 5 dana korištenja mogu reći da uopće ne djeluje. Pila sam ibutamoren od driade više od 10 puta, svaki put je imao jako gorak okus, a nakon uzimanja čak i 10 mg odmah je počela glad. Naručila sam ovu seriju od 7 pakiranja, uopće nema gorak okus, a tablete čak nemaju ni otisnut logo driade. Testirala sam 20-40, pa čak i 60 mg bez ikakve razlike. Isprobala sam svako pakiranje samo da budem sigurna. Naručeno je kao i svaka druga narudžba koju sam napravila od driade i nikad nisam imala ovaj problem. Ali tablete su stvarno drugačije i uopće ne djeluju... Ima li netko slično iskustvo? Ovo je komentar u telegram grupi. Odnosi se na posljednju seriju mk. Imam istu i mogu potvrditi sve što je rekao. Uzimam je prije spavanja. Ne spavam bolje, a jedem jako malo, čak 1600-1800 kcal i uopće nemam apetita. Dakle, nisam zadovoljan, to je samo moje iskustvo. Kao i ovaj gospodin koji je napisao u telegram grupi
Probaj kikiriki maslac na žlicu
 
Will Drostanolone Enanthate be in stock this week again? Would want to order Drostanolone together with this weeks product of the week
Of course, drostanolone will be in stock, but so far it's hard for me to say a specific date. I need some time for answering.
 
Hi, I have a question regarding your Minoxytop 5 mg Minoxidil tablets. Why do the QR codes on my packages show Bromoheal 2.5mg instead of minoxidil? Can anyone verify if this product is genuine? All my packages and blisters show batch number TM-1260018 but all QR cudes show Bromoheal
 
Hi, I have a question regarding your Minoxytop 5 mg Minoxidil tablets. Why do the QR codes on my packages show Bromoheal 2.5mg instead of minoxidil? Can anyone verify if this product is genuine? All my packages and blisters show batch number TM-1260018 but all QR cudes show Bromoheal
Yes, we learned about this situation from our customers. We purchase this product directly from the supplier, and it seems they made a printing error, so the QR code leads to a different product. Unfortunately, we cannot influence this in any way. I assume they have corrected this mistake in their next batch.
 
Back
Top